Under_Rider
Grom
Reged: 01/07/06
Posts: 12
Loc: The Land of No Points
|
|
Guys forgive my ignorance but I was looking at Larry's Twinzer fish as an addition to my collection of high performance 'fishy' boards and was wondering what are the chief differences between the twinzer and quad set-ups? I would appreciate any feedback on this shape. Thanks?
|
WarrenC
Michael Peterson status
Reged: 11/30/08
Posts: 2748
|
|
bump..
would like to know the same.
--------------------
What fin sets work well with this board.
|
Brrr
Legend (inyourownmind)
Reged: 03/04/08
Posts: 399
Loc: New England
|
|
I have never surfed one of his boards, however I have surfed the Twinzer set-up on a few different boards. It has a more wind up and release compared to a quad, almost like a thruster. It is a like a supercharged twin, way more drive. I have noticed some guys putting their twins closer to the tail, might have the same riding characteristics 
|
GDaddy
Phil Edwards status
Reged: 01/16/06
Posts: 7105
Loc: Carlsbad
|
|
I favor a twinzer setup for my personal small wave boards. I'd call the ride more similar to a twin, except that it holds a lot better, especially when going backside. They don't slide out when on set on a rail at a critical angle. I consider it the quickest fin setup 0-60, but for me it does seem to have limitations on the top end. I like quads better for the bigger waves.
One thing I've noticed is that a couple of the performance twin shapers seem to be following Griffen's lead in moving their fins back closer to the tail. I did that with my latest fish and a Probox/Bing Keel Hauler fin setup (which is a variation of the twinzer) and it's become my favorite setup for a small-wave fish, lots better for me than a keel or a quad.
I think you have to be careful about fin sizes with twinzers. Most twinzer sets I've seen from FCS/Futures use a main twin fin thats a little small for anyone over 180#. Most installations I've seen don't cant the leader fin as much as I like, either. If I'm using a 6* cant on the main drive fin, I want the cant for the leader fin at a minimum of 10* if I can get it.
|
GDaddy
Phil Edwards status
Reged: 01/16/06
Posts: 7105
Loc: Carlsbad
|
|
 
|
obslop
Michael Peterson status
Reged: 02/04/02
Posts: 2615
Loc: san diego, CA
|
|
I've ridden one of Larry's twinzer fish (numerous times) and it is without a doubt the fastest board in crap surf I have ever been on . . . and I've been on a lot of different boards in a lot of crap surf. The turning capabilities with the twinzer set-up are fine for what you would expect for a wide, low rocker board.
If you're already leaning toward a wider template/low rocker board, I'd go with the twinzer over the quad. It's not like a quad set-up is going to give you that much more of a performance increase if your board is already 20" + inches wide - speed and flow is all you need with that style of board.
|
20W-50 and blood
Duke status
Reged: 02/04/04
Posts: 16755
Loc: SOCAL
|
|
Quote:
only caught three waves but this baord was DAMN fun. I still cant believe i was abel to ride it..let ALONE actually have fun on it.
--------------------
Jesus was Mexican, Ronald Reagan was the devil, and the government is lying about 9-11.
|
Oceanslide
Miki Dora status
Reged: 03/04/08
Posts: 5177
Loc: Oceanside, CA
|
|
Quote:
Quote:
only caught three waves but this baord was DAMN fun. I still cant believe i was abel to ride it..let ALONE actually have fun on it.
That was GDaddy that made that board at the Fry?
I can't believe you rode that thing either! 
That fin set-up looks pretty sweet!
--------------------
"Surfing reminds us of how good life is."
Oceansliding
|
FishFace
Michael Peterson status
Reged: 08/07/09
Posts: 2897
Loc: Del Mar, CA
|
|
I have a 5'11" and it is SICK. He has double concave going thru the tail inside the fins. Not flat like the Hynson twinzer. I highly suggest getting one.
I got the 5'11" after riding my cousins 6'2" (which is a monster) and it is truly a magic board for me.
As for the difference between the quad. The twinzer is a little bit more loose but much faster...
--------------------
|
rid
Gerry Lopez status
Reged: 11/20/08
Posts: 1068
Loc: Long Beach, CA
|
|
I had a Hynson and it had double concaves out the back. very fast. maybe a bit tracky.
|
Oceanslide
Miki Dora status
Reged: 03/04/08
Posts: 5177
Loc: Oceanside, CA
|
|
Quote:
I have a 5'11" and it is SICK. He has double concave going thru the tail inside the fins. Not flat like the Hynson twinzer.
No doubt that the Mabile twinzers work unreal, but the
Hynson twinzer bottom is not flat as the other poster
mentioned. Would like to try a Mabile....
--------------------
"Surfing reminds us of how good life is."
Oceansliding
|
dawnpatrol77
Legend (inyourownmind)
Reged: 09/03/07
Posts: 487
Loc: between sunrise and a swell
|
|
I have a 6'2 KG Mabile Twinzer. The board is amazing. Deep double concave, rides backside amazing which is what i mainly surf. I like it better than the twin I had but wish it was 2-3" shorter. 5'11 would be a much better fit for me. (6'2 185 lb) I would highly recommend Larry's boards to just about anyone. They're magic.
--------------------
No Soup For You!
|
20W-50 and blood
Duke status
Reged: 02/04/04
Posts: 16755
Loc: SOCAL
|
|
you have WHAT?
--------------------
Jesus was Mexican, Ronald Reagan was the devil, and the government is lying about 9-11.
|
FishFace
Michael Peterson status
Reged: 08/07/09
Posts: 2897
Loc: Del Mar, CA
|
|
Quote:
Quote:
I have a 5'11" and it is SICK. He has double concave going thru the tail inside the fins. Not flat like the Hynson twinzer.
No doubt that the Mabile twinzers work unreal, but the
Hynson twinzer bottom is not flat as the other poster
mentioned. Would like to try a Mabile....
Ok I am the "other poster" and I do own both twinzers(5'11 Mabile and a 5'9" Hynson). After looking at both of them the Hynson has a SLIGHT concave. The mabile is much more pronounced and deep - almost(I'm saying almost - guys) to the point of Campbell Bros. concave (yes I have one of them too) but the Larmo doesnt carry thru the back like the bonzer. The concave is starts about 12" before the fins and mellows out after rear fin. . I had another larger Hynson twinzer (5'11") and it was totally flat thru the back... I guess your results may vary.
I am very surprised his shapes are not mentioned on here much.
--------------------
|
sjc
Nep status
Reged: 06/30/04
Posts: 821
Loc: so. cal.
|
|
my 5'5"...love it ! fast !
|
Oceanslide
Miki Dora status
Reged: 03/04/08
Posts: 5177
Loc: Oceanside, CA
|
|
Quote:
Larmo has a shop in PB across from Taco Surf. You should check him out.
Was just at Taco Surf yesterday and saw a few people in
the old Star Surf shop, although it looked empty still.
Is he taking that over?
BTW, I was referencing the 'other poster' that said his
Hynson had concave and was not flat.
--------------------
"Surfing reminds us of how good life is."
Oceansliding
|
rid
Gerry Lopez status
Reged: 11/20/08
Posts: 1068
Loc: Long Beach, CA
|
|
i guess there are some differences between even Hynsons, since fishface mentioned having had flat bottom, mine had double concaves, and i have seen in person one that had very pronounced double concave out the back.
Bottom line: both hynsons and mabile's boards fly!
|
Havoc
Tom Curren status
Reged: 09/10/07
Posts: 10000
Loc: The OC Life
|
|
Quote:
my 5'5"...love it ! fast !
Holy smokes that thing is beautiful!
I like my Hynson twinzer, super fast in the small stuff.
I'd like to try one of the mabile's some day...
Havoc
--------------------
"motions of rippage is initated by the hind leg"-Northern_Shores
"Lemme know. I got endson gas"-20W
|
FishFace
Michael Peterson status
Reged: 08/07/09
Posts: 2897
Loc: Del Mar, CA
|
|
Quote:
my 5'5"...love it ! fast !
Beautiful.
--------------------
|
FishFace
Michael Peterson status
Reged: 08/07/09
Posts: 2897
Loc: Del Mar, CA
|
|
Quote:
Quote:
Larmo has a shop in PB across from Taco Surf. You should check him out.
Was just at Taco Surf yesterday and saw a few people in
the old Star Surf shop, although it looked empty still.
Is he taking that over?
BTW, I was referencing the 'other poster' that said his
Hynson had concave and was not flat.
woops Im wrong about the location. Forgive me.
--------------------
|
rid
Gerry Lopez status
Reged: 11/20/08
Posts: 1068
Loc: Long Beach, CA
|
|
Is there any difference in the way mabile rides as compared to a hynson? The outline is certainly different. i am assuming rails are slightly different too. Hard down rail?
|
FishFace
Michael Peterson status
Reged: 08/07/09
Posts: 2897
Loc: Del Mar, CA
|
|
Quote:
Is there any difference in the way mabile rides as compared to a hynson? The outline is certainly different. i am assuming rails are slightly different too. Hard down rail?
They both have the hard down rail. In comparing the 2 boards - The Hynson has the rear fins further back. I think the KG is much more loose while the Hynson has a tad more hold (like u said Rid, trackier -probably from the rear set fins). The real difference is the acceleration. Mabile wins this race, hands down. Its strange to say more loose but accelerates faster..
--------------------
Edited by FishFace (10/04/09 10:46 PM)
|
easternbull
Legend (inyourownmind)
Reged: 08/26/05
Posts: 366
Loc: Northern Europe
|
|
Have not tried Larry's twinzer but hes a fantastic shaper, been shaping fish as long as Pavel, only Lis/Frye have more experience in that department. Great guy with excellent customer service. 
back to subject heres some info on his twinzers from coque combined with halcyon's fins:
http://www2.swaylocks.com/node/1023944
|
laidback
Miki Dora status
Reged: 02/09/07
Posts: 4192
Loc: NOC
|
|
I can't believe I just bought this
5-8 x 21
It might be a tad small, but we'll see 
--------------------
"You can observe a lot just by watching."
|
laidback
Miki Dora status
Reged: 02/09/07
Posts: 4192
Loc: NOC
|
|
I'm not sure about the fins, G3000
I'm not a fcs guy, so do these seem right?
they don't look right to me.
--------------------
"You can observe a lot just by watching."
|
FishFace
Michael Peterson status
Reged: 08/07/09
Posts: 2897
Loc: Del Mar, CA
|
|
that board is sweet...
you want to run a twinzer front canard with a larger twin fin like the MR template...
canards cheap on ebay:
http://www.ebay.com/itm/NEW-FCS-Twinzer-...b#ht_4005wt_982
--------------------
|
laidback
Miki Dora status
Reged: 02/09/07
Posts: 4192
Loc: NOC
|
|
I'm good on the canard.
I'll have to see about finding a MR style fin
--------------------
"You can observe a lot just by watching."
|
kellsmith
Miki Dora status
Reged: 04/18/11
Posts: 3706
Loc: South Bay
|
|
try it like it is right there. with such a large canard, the smaller main might feel pretty cool. at least, youll be able to contrast it with MR + small canard
--------------------
The glide shall not be truncated 
- roy
|
laidback
Miki Dora status
Reged: 02/09/07
Posts: 4192
Loc: NOC
|
|
Im going to try them tomorrow, i hope there will some kinda wave.
The fins in there feel cheap - they flex like crazy with hardly any effort
--------------------
"You can observe a lot just by watching."
|
twinzerfan
Gerry Lopez status
Reged: 10/26/06
Posts: 1201
Loc: Santa Cruz
|
|
I personally find that it all boils down to cumulative area - to a degree.
but, you can run smaller fins than normal in twinzers thanks to the attachment of the flow. But, that is personal taste, like everything...
nice board. Surfed Bird Rock with Larmo yesterday and he was on a twinzer long board of his. smooth...
--------------------
rob
RightCoastKook!
|
laidback
Miki Dora status
Reged: 02/09/07
Posts: 4192
Loc: NOC
|
|
TStamps let me borrow these fins he had laying around.
They look a little big, but giving it a go
--------------------
"You can observe a lot just by watching."
|
Previous
Index
Next
Threaded
Edit
Reply
Quote
